Model: | AE1475G225 | Nut: | Diecast Aluminum |
---|---|---|---|
Ferrule: | 304SS | Armature: | 430FR SS |
Diaphragm And Seals: | PTFE | Spring: | 304SS |
Screws: | 302SS | Outlet Pipe: | Schedule 40 Wrought Steel Zinc Passivated |
High Light: | AE1475G225, G3 Pulse Jet Valves, Integrated Pulse Jet Valves |
Autel AE1475G225 High Performance Integrated valve G3″ Tank valve
Dust collector applications , in particular for reverse pulse jet filter cleaning including bag filters , ceramic filters , and sintered metal fibre filters.
General Description
In the high efficiency series we can include the range of flat surface valves. These valves, used for cleaning filter elements in air filtration systems, are specifically designed for flat surfaces like square header tanks and flanged tank. Like traditional model, with threaded and coupling connection, the activating can be:
Integrated the pilot is placed on the valve and the excitation (electric) is made by a coil.
Remote: the pilot is remote and the excitation is pneumatic. The connection between pilot and valve is made by a simple pneumatic tube.
All That is achieved from a deep studying of internal geometrical characteristics and from a technological research on diaphragm. This guarantees rapid opening-closing cycles and a working for over a million of shots.
Installation
1. Autel Pulse Jet Valves AE1475G225 valves are installed through the tank, refer to the appropriate template listed above.
2. To avoid any potential operational problems it is preferable that the valves are not mounted underneath the tank where condensation may collect. All o-rings should be coated with a silicone based lubricant or similar.
3. Dresser nut seals where used are a pressure seal only, not a structural component. Do not rely on dresser seals to retain either the tanks or blowtubes. Tanks and blowtubes must be independently restrained.
4. Tighten dresser nuts to 20Nm (15 ftlbs) max.
5. Tighten pipe outlets to 20 Nm (15 ftlbs).
6. Connect to Goyen pilot valve, if remotely actuated.
7. Ensure compressed air supply is dry and free from oil and dirt.
8. Check all cleaning system components are secure before applying pressure.
9. Apply moderate pressure and check for leaks.
10.Fully pressurise system.
11.Test fire and listen for proper actuation and crisp pulse noises.
Construction | |
Body | Aluminum (Diecast) |
Washer | SS 304 |
Armature | SS 430FR |
Core and Plugnut | Stainless steel |
Core Spring | SS 304 |
Sealing & disc | NBR(nitrile/buna-n) |
Screws | SS302 |
Diaphragm | PA-6(Standard), Viton |
Connector | Pg9 IP65 |
Voltage | 230-150-24 V / 50-60 HZ AC 24 V DC |
Working Temperature | -20 to +85℃ Nitrile seals -29 to +232℃ Viton seals |
Power Absorption | 17 VA AC / 17 W DC |
Conn.Insulation class | C-VDE 0110 |
Connector specification | Din 43650 – IS0 4400 |
Max Pressure | 8 Bar |
Recommended on time range | 50-500ms |
Recommended time between pulses | 1 minute or Less |